Maguire Green Clean are professionals when it comes to pressure washing decking in Dublin.Pressure washing decks is an important upkeep task that every homeowner should do annually to keep your deck looking good.
Step 1: Consider your decking size
No matter what type of decking you have, the first step in pressure washing your deck is to determine the size. This will help you determine the amount of pressure and water you’ll need to effectively clean your deck. If your deck is small, you can use a standard garden hose with a nozzle attachment. For larger decks, you’ll need a pressure washer.
Once you know the size of your deck, it’s time to start pressure washing. Begin by wetting down your deck with a garden hose or pressure washer. Be sure to start from the top and work your way down. This will help prevent streaking and ensure that all dirt and debris are removed.
For best results, use a wide-angle nozzle when pressure washing your deck. This will help evenly distribute the water and prevent any damage to your decking material. When using a pressure washer, always start with the lowest setting and slowly increase the pressure if needed. Remember, too much pressure can damage your decking material!
Step 2: Prepare the pressure washer for the job
If you’re going to be pressure washing your decking, you’ll need to take a few preparatory steps first. First, make sure that the pressure washer is properly set up and that all of the hoses and connections are secure. Next, fill the pressure washer’s reservoir with the appropriate amount of water for the job. Finally, add the required amount of detergent or cleaner to the reservoir. Once all of these steps have been completed, you’re ready to begin pressure washing your deck!
Step 3: Start with a gentle spray
Assuming you have a pressure washer, start with a gentle spray. You don’t want to use too much pressure and damage the decking. Just hold the pressure washer nozzle about a foot from the surface of the deck and make sure the tip is pointing down at a 45-degree angle. Move the nozzle in a sweeping motion across the entire surface of the deck.
Step 4: Apply soap to the area you are washing
If you’re pressure washing your decking, you’ll want to make sure that you apply soap to the area before you start. This will help to remove any dirt or grime that may be on the surface.
To do this, simply add some pressure washing soap to your pressure washer and then turn it on. Apply the soap to the area you’re going to be washing and then let it sit for a few minutes. This will help to loosen up any dirt or grime that’s on the surface.
Step 5: Slowly increase pressure on the downstroke
If you’re using a pressure washer for the first time, it’s important to get a feel for how much pressure it exerts. Slowly increase the pressure on the downstroke while holding the wand about six inches from the surface of your decking. Be careful not to hold the wand too close to the surface, as this can damage the wood. As you increase the pressure, you’ll see the dirt and grime start to loosen and lift away from the wood. Continue increasing the pressure until you reach a comfortable level that removes all of the dirt and grime without damaging the wood.
Step 6: Rinse and repeat
Now that you know the best way to pressure wash your decking, it’s time to get out there and start cleaning! Remember to always start with a low pressure setting and work your way up if needed. Be sure to rinse the decking thoroughly after washing to remove any soap residue. Repeat this process as needed to keep your deck looking its best.